I am trying to FTP the files located in OUTLIST from the UTILITIES of the RFE menu option of MVS TK4.
This would be JES output from an assembled job. From the HERCULES cmd line I start the FTP server by running, "/start ftpd,srvport=2100"
Then using Windows 10 cmd, I attempt to access by calling, "ftp> open localhost 2100"
I get a response of:
Code: Select all
"Connected to DESKTOP-MTC79OU.
220 *** MVS38j FTP Daemon on TK4- ***
500 Huh?
User (DESKTOP-MTC79OU:(none)):"
when I run a get on it, a password is requested and whatever I enter (including CUL8TR the default Hercules pw) it will accept it and say I am now logged in. But my attempts to FTP the output responds like so:
Code: Select all
ftp> get SYS19027.T063014.RA000.HERC01.JOB00096
200 PORT command successful
550 SYS19027.T063014.RA000.HERC01.JOB00096: 13
ftp> get JOB00096
200 PORT command successful
553 JOB00096: Access denied.
ftp> GET 'JOB00096'
200 PORT command successful
553 'JOB00096': Access denied.
I apologize if this is vague, but I am just trying to get a good setup to be able to write the program and view the output in notepad, but do it with Hercules. I have already spent a few wasted nights researching, and trying different ways to do this without luck. .
Any suggestions? Thank you!