Hi MVS experts,
Below is results of execution D IOS,MIH command:
IOS086I 18.59.15 MIH AND IOT TIMES 462
MOUNTMSG = YES, HALT=00:05, MNTS=05:00, UREC=03:00,
DASD=00:15, TAPE=03:00, GRAF=03:00, CTC =03:00, COMM=03:00,
CHAR=03:00, IOTDASD=00:00,
US01=00:30 UDEV=0A80, 0A81, 0A82, 0A83, 0A85, 0A86, 0A87, 0A88,
Who could tell me, which MVS control blocks contain the values of MOUNTMSG and MNTS ?
Thanks a lot in advance !
D IOS,MIH - source ?
-
- Global Moderator
- Posts: 826
- Joined: Wed Sep 11, 2013 3:57 pm
Re: D IOS,MIH - source ?
the values displayed are those set by the IECIOSxx member used
they are READ ONLY values used by the MIH to take the appropriate actions
the manual has the description of all the keywords and the default values
so no control block lurking is needed
if no IECIOSxx member was used the values shown are the default ones
( same effect as having a IECIOSxx member with the default vaules explicitly specified )
they are READ ONLY values used by the MIH to take the appropriate actions
the manual has the description of all the keywords and the default values
so no control block lurking is needed
if no IECIOSxx member was used the values shown are the default ones
( same effect as having a IECIOSxx member with the default vaules explicitly specified )
cheers
enrico
When I tell somebody to RTFM or STFW I usually have the page open in another tab/window of my browser,
so that I am sure that the information requested can be reached with a very small effort
enrico
When I tell somebody to RTFM or STFW I usually have the page open in another tab/window of my browser,
so that I am sure that the information requested can be reached with a very small effort
Re: D IOS,MIH - source ?
Hello Enrico,
Thanks a lot for your feedback.
I have to check these values in the code that enhances a tape management system.
Of course the program could read the IECIOSxx member or issue D IOS,MIH command and analyze
a reply from MIH but this way is not too intelligent and can in certain cases provide incorrect data.
Anyway there are must be control blocks which contain these values.
Cheers
Alex
Thanks a lot for your feedback.
I have to check these values in the code that enhances a tape management system.
Of course the program could read the IECIOSxx member or issue D IOS,MIH command and analyze
a reply from MIH but this way is not too intelligent and can in certain cases provide incorrect data.
Anyway there are must be control blocks which contain these values.
Cheers
Alex
- Robert Sample
- Global Moderator
- Posts: 1895
- Joined: Fri Jun 28, 2013 1:22 am
- Location: Dubuque Iowa
Re: D IOS,MIH - source ?
Certainly -- but that does NOT mean that IBM has made knowledge of those particular control blocks public. If IBM has not published the data about them, then you're not going to be very successful at using them.Anyway there are must be control blocks which contain these values.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute